ASROCK Penryn1600SLI-110dB Mode D'emploi page 21

2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors
2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper
caps over the headers and connectors will cause permanent dam-
age of the motherboard!
FDD connector
(33-pin FLOPPY1)
(see p.2 No. 24)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE Connector (Blue)
(39-pin IDE1, see p.2 No. 10)
connect the blue end
to the motherboard
80-conductor ATA 66/100/133 cable
Note: If you use only one IDE device on this motherboard, please set the IDE
device as "Master". Please refer to the instruction of your IDE device vendor
for the details. Besides, to optimize compatibility and performance, please
connect your hard disk drive to the primary IDE connector (IDE1, blue) and
CD-ROM to the secondary IDE connector (IDE2, black).
Serial ATAII Connectors
(SATAII_1: see p.2, No. 15)
(SATAII_2: see p.2, No. 12)
(SATAII_3: see p.2, No. 14)
(SATAII_4: see p.2, No. 13)
Serial ATA (SATA)
Data Cable
(Optional)
ASRock Penryn1600SLI-110dB Motherboard
Secondary IDE Connector (Black)
(39-pin IDE2, see p.2 No. 9)
These four Serial ATAII (SATAII)
connectors support SATA data
cables for internal storage
SATAII_2 SATAII_4
devices. The current SATAII
interface allows up to 3.0 Gb/s
SATAII_1 SATAII_3
data transfer rate.
Either end of the SATA data cable
can be connected to the SATA /
SATAII hard disk or the SATAII
connector on this motherboard.
the red-striped side to
Pin1
connect the black end
to the IDE devices
2 1 2 1
2 1
2 1
2 1