Turning On/Off - Altec Lansing AL-CAQ Mode D'emploi

cancellation is not required, the ALCORA can also be used like conventional headphones, without
the use of batteries.
• Once the battery is fully drained, the active noise cancelling feature will turn off but the audio
signal from the music player will continue to transmit.
Bluetooth Function
M ain Functions

Turning ON/OFF:

1. Turn ON your headphones:
Press and hold the Multifunction Button (MFB) for about 3 seconds until the Bluetooth LED
indicator light starts flashing green/red rapidly with an ascending sound.
3. Turn OFF your headphones: Press and hold the MFB for about 5 seconds until the Bluetooth
LED indicator light turns solid red with a descending sound and then goes off.
Pairing your Headphone:
The headphone works with Bluetooth-enabled phones. Prior to using and pairing your headphone
for the first time, please check to make sure your mobile phone is Bluetooth-enabled.
The pairing instructions for typical Bluetooth-enabled mobile phones are explained in "Pairing
Your Headphone." The headphone pairing procedure may vary depending on the settings of your
mobile phone. Please contact the manufacturer of your mobile phone or its agent for further
information.
1. Press and hold the MFB for about 4 seconds until the Bluetooth LED indicator flashes and
alternately between green and red. The ALCORA will now enter into pairing mode.
2. Enable searching of nearby Bluetooth devices using the Bluetooth menu on your device.
3. Once the "ALCORA" is found, you can now connect and pair. If your device prompts you for a
password, please use "0000". For more details, please refer to your device's user manual.
4. When pairing is successful, the Bluetooth LED indicator will flash blue every 3 seconds. If
pairing is unsuccessful, please turn off the ALCORA headphone and repeat the pairing steps.
After initial pairing is established, the headphones will automatically reconnect to the last paired
device upon turning ON.
Note:
ALCORA can be paired with two Smartphone at the same time.
To add a second device: Turn the ALCORA OFF and repeat the above pairing instructions.
If ALCORA was previously paired to a Smartphone, it is possible to be paired with a 2nd
Smartphone: restart ALCORA (switch off and switch on) to enter pairing mode; repeat the above
pairing procedure to pair ALCORA with the 2nd Smartphone; and then reconnect ALCORA with
1 st Smartphone; finally two Smartphone can connect with ALCORA.