Canvas FHTS80048C Mode D'emploi page 15

28 Product No. 085-1578-8 | Model No. FHTS80048C
Burner will not light using igniter
Burner will not light with match
LP gas tank valve is closed
LP gas tank is low or empty
LP gas leak
Battery needs to be changed
Electrode and burners are wet
Electrode cracked or broken — sparks at crack
Wire loose or disconnected
Wire is shorting (sparking) between
igniter and electrode
Bad igniter
No gas flow
LP gas tank is low or empty
LP gas leak
Coupling nut and regulator not fully connected
Obstruction of gas flow
Disengagement of burner to valve
Spider webs or insect nest in burner/venturi tube
Burner ports clogged or blocked
Make sure regulator is securely attached to the LP gas tank per
"Installing LP Gas Tank," then turn LP gas tank valve to "OPEN"
Exchange, refill or replace LP gas tank
1. Turn LP gas tank valve to "CLOSED"
2. Wait 5 minutes for gas to clear
3. Follow "Checking for Leaks" section
Replace the "AAA" battery (follow assembly step for inserting battery)
Wipe dry with cloth
Replacement part(s) may be needed — contact Customer Care at
1-888-670-6684
Replacement part(s) may be needed — contact Customer Care at
1-888-670-6684
Replacement part(s) may be needed — contact Customer Care at
1-888-670-6684
Replacement part(s) may be needed — contact Customer Care at
1-888-670-6684
Check if LP gas tank is empty
a. If empty, exchange, refill or replace LP gas tank
b. If LP gas tank is not empty, refer to "Sudden drop in gas flow or
reduced flame height" (see below)
Exchange, refill or replace LP gas tank
1. Turn LP gas tank valve to "CLOSED"
2. Wait 5 minutes for gas to clear
3. Follow "Checking for Leaks" section
Turn the coupling nut about one-half to three-quarters additional
turn until solid stop. Tighten by hand only — do NOT use tools
1. Clear burner/venturi tube
2. Check for bent or kinked hose
Re-engage burner and valve
Clean burner/venturi tube
Clean burner ports
29