Haier HP200M3 Manuel D'installation Et D'utilisation page 4

Safety instructions (to be followed at any time)
The outlet water temperature
of a water heater is typically
higher than the temperature
indicated on the display. Hot
water shall not be pointed at
the human body immediately
after opening the hot water
valve to avoid injury caused by
hot water.
Install the water heater in
strict accordance with the
installation
specified on page 11-23.
Hands or other items shall not
be put into the air grille to
avoid injury or damage to the
water heater.
The water heater is intended to be permanently
connected to the water mains and not connected by a
hose-set.
Do not install the water heater in the position where
exposed to gas, vapours or dust.
The inlet water pressure is between 0.1-0.5MPa. The
inlet water temperature is suggested between 10-30°C.
instruction
Means for disconnection from
the main supply having a
contact separation in all poles
that provide
disconnection
overvoltage
conditions
incorporated in the fixed
wiring in accordance with the
wiring rules.
If the power cord is damaged,
it shall be
qualified professionals
avoid hazards.
Maintenance shall be carried
out according
instructions
page 27.
full
under
category
must
replaced
to the
specified on
III
be
by
to