eTIGER Cosmic LED A0 -CL01U Mode D'emploi page 12

EN
This product bears the selective sorting symbol for waste electrical and electronic equipment (WEEE). This means that this product must be handled
pursuant to European Directive 2002/96/EC in order to be recycled or dismantled to minimize its impact on the environment.
For further information, please contact your local or regional authorities.
Electronic products not included in the selective sorting process are potentially dangerous for the environment and human health due to the presence
of hazardous substances.
This product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. The declaration of conformity may
be consulted at Etiger website www.etiger.com, 'DOWNLOAD' in the menu bar.
This product was designed and manufactured in compliance with Directive 2002/95/EC of the European Parliament and of the Council on the
restriction of use of certain hazardous substances in electrical and electronic equipment (RoHS Directive - Rohs) and is deemed to comply with the
maximum concentration values set by the European Technical Adaptation Committee (TAC).
FCC
FCC Radio Frequency Interference Requirements
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help.
Radio Transmitters (Part 15)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user' s authority to operate the equipment.
FCC RF Exposure Guidelines
Safety Information
Reducing RF Exposure - Use Properly
Only operate the device in accordance with the instructions supplied.
This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the
FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 20cm (8 inches) during normal operation.
FCC ID: 2AAUHA0-CL01
Product designed in France, assembled and made in China.
Before using the product, make sure your device is equipped with the Bluetooth technology. Refer to your device manual and contact your
device manufacturer in case of connection failure.
The remote control's functionalities may vary depending on the device model, the firmware, and/or the application.
FR
Ce produit porte le symbole du tri sélectif pour les équipements électriques et électroniques (DEEE). Cela signifie qu'il doit être traité
conformément à la Directive européenne 2002/96/EC afin d'être recyclé ou démantelé pour minimiser son impact sur l'environnement. Pour de
plus amples informations, veuillez contacter les autorités locales ou régionales.
Les produits électroniques qui ne font pas l'objet d'un tri sélectif sont potentiellement dangereux pour l'environnement et la santé humaine en
raison de la présence de substances dangereuses.
Ce produit satisfait aux exigences fondamentales et autres conditions pertinentes de la Directive 1999/5/EC. La déclaration de conformité est
disponible sur le site Web d'Etiger, à l'adresse www.etiger.com, dans la barre de menu « DOWNLOAD ».
Ce produit a été conçu et fabriqué en conformité avec la Directive 2002/95/EC du Parlement européen et du Conseil relative à la limitation de
l'utilisation de certaines substances dangereuses dans les équipements électriques et électroniques (Directive RoHS) et est déclaré satisfaisant
aux valeurs de concentration maximum définies par le Comité technique d'adaptation (European Technical Adaptation Committee – TAC)
européen.
Produit conçu en France, assemblé et fabriqué en Chine.
11