Safety Instructions - Walter Surface Technologies BIO-CIRCLE MAXI 600C Manuel De L'utilisateur

SAFETY INSTRUCTIONS

BIO-CIRCLE™ Parts Cleaning Systems are produced in accordance with
applicable standards governing the manufacture, performance and safety of
industrial products.
WARNING: Before using this machine, read all safety and operating instructions
carefully and save this owner's manual for future reference. When using this
parts cleaning system, basic safety precautions should always be observed to
reduce the risk of fire, electric shock and personal injury, including the following:
1. Read this owner's manual to familiarize yourself with the unit's operation, its
particular features, applications and limitations.
2. Parts that are damaged or otherwise defective should be repaired or
replaced.
3. Adequate ventilation should be provided when operating the unit. Keep work
areas clean. A cluttered environment invites accidents.
4. Keep children and other persons at a safe distance from the work area. Do
not let unqualified persons handle this machine.
5. Your BIO-CIRCLE™ machine is equipped with a magnet inserted underneath
the grated receptacle in the sink. Always handle it with care, as it will shatter
if dropped and may cause injuries. Keep magnet away from electronic
devices and magnetic media such as floppy discs, credit cards and computer
monitors. Keep magnet away from pacemakers.
6. Do not contaminate the cleaning solution with any flammable or combustible
substances such as gasoline, alcohol, mineral spirits, solvents etc. Drain
parts to be cleaned of any flammable or combustible material before placing
them into cleaning sink. Even small quantities can create a fire hazard. Do
not introduce into the unit any cleaning solution other than Bio-Circle L™
and Bio-Circle Ultra™ as this will cause malfunctions.
7. The circulation pump & heater coil must always be immersed. Failure to keep
the solution at the proper level can result in a burned-out pump or
overheating heater coil thereby creating a potential fire hazard. To help
prevent this, the unit is equipped with a liquid level sensor and a high
temperature limit switch, which will shut off the pump and the heater coil
when the liquid level is low.
8. CAUTION: Used cleaning solution may be irritating to skin and eyes. While
working, always wear appropriate gloves and approved safety goggles.
First Aid: If used cleaning solution is splashed on clothing, change promptly.
Thoroughly wash any body areas that have been in contact with the solution.
Saturated clothing must not remain in contact with skin.
Eye Contact: Flush with water for 15 minutes, lifting eyelid often. See a
physician if required.
Ingestion: Rinse mouth and drink plenty of water. See a physician if
required.
Please refer to WALTER Bio-Circle L™ and Bio-Circle Ultra™ MSDS
No.: L-78E and L-148E for complete safety data information.