Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
water.
If the water is very
dirty,
Checking that the seal is present and that the cap is screwed on properly.
Fill the water tank again.
Turn the appliance on again.
Before
iraning,
release steam into the sink or another container and check that the steam is
clean. This should take a few seconds.
Resume ironing normally.
TROUBLESHOOTING
PROBLEM
Water cornes out of the iran
instead of steam
The appliance is on but it is not
producing steam
Suggestions
Divide the washing according to the correct iraning
that require a lower temperature. For fuller details, refer to the chart at end of this booklet.
Fabrics such as velvet and wool, and accessories such as gloves,
brand-new look and texture by simply passing the iran near the surface of the fabric and pressing
the steam
button.
lmprints left in carpets by furniture can be removed by applying steam on the parts where the pile is
crushed and the brushing lightly.
_I f the carpet is made of synthetic material, do not select a high temperature.
How to get a professional ironing finish
A normal iran generates only a small quantity of steam. ln this case it is necessary to praducts
steam constantly in order to eliminate crease in the fabric being iraned.
A professional iraning system works rather differently. The fabric is first made damp by the
steam and
then,
in a second
Tiniest crease is removed and your garments are iraned to perfection.
the first phase (steam-damping of the fabric),hold the iran about 20 cm above the fabric and
ln
press the steam(3). Pass the iron over the garment in a circular movement so that the powerful
jet of steam damps the fabric. Lightly creased garments require only a few moments of
steaming.
While very heavy fabrics or garments with particularly difficult creases must be
damper,
so steam must be applied for a few seconds
During the second phase (dry
for the type of fabrics; release the steam button(3) and dry-iran the garment. The special
iraning plate will prevent the fabrics from becoming shiny. Using this iraning
following the suggestions in the chart
prafessional iraning finish.
repeat the operation until it is clean.
CAUSE
The appliance has not reached
the right temperature yet.
The temperature contrai dial
has set at the minimum.
Water tank is empty or not
inserted correctly.
phase,
dry-ironed in the normal way. This means that
iraning),
check that the thermostat knob is in the correct position
below,
you
will
Wail for the "Steam Ready"
indicator light and the iran
indicator light to turn off.
lncrease the regulation of the
temperature contrai dial.
Fill
the water tank.
temperatures.
Start by iraning those garments
handbags,
more.
find it easy to give your garments a really
SOLUTION
etc. will regain their
every.
technique,
and
Publicité
Table des Matières
