Table Des Matières; Safety Information; Pre-Installation; Planning Installation - Et 54074343 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Table of Contents
Table of Content ......................................... 2
Safety Information...................................... 2
Warranty ..................................................... 2
Pre-Installation........................................... 2

Planning Installation............................. 2

Tools Required ..................................... 3

Safety Information

WARNING: Carefully read and understand the information
given in this manual before beginning the assembly and
installation. Failure to do so could lead to electric shock, fire,
or other injuries which could be hazardous or even fatal.
WARNING: Ensure the electricity to the wires you are
working on is shut off. Either remove the fuse or turn off the
circuit breaker.
WARNING: Changes or modifications not expressly
approved by the party responsible for compliance could void
the user's authority to operate the equipment.
NOTICE: Suitable for damp locations. Minimum 75° C
supply conductors. Minimum 90° C supply conductors
(54618244).
Limited Warranty
This product is warranted for a period of 5 years from the date of original purchase against defects in materials
and workmanship. If this product should fail to operate due to defects in material or workmanship within 60
months of purchase, see www.ETiSSL.com for details. This product will be repaired or replaced, at ETi's option.
This warranty is expressly limited to repair or replacement of product and liability for direct, incidental, or
consequential damages is hereby expressly excluded. Some states do not allow exclusions of direct, incidental
or consequential damages so the above limitation of exclusion may not apply to you. This warranty gives the
consumer specifc legal rights, which vary from state to state. WARRANTY IS VOID IF PRODUCT IS NOT USED FOR
THE PURPOSE WHICH THIS PRODUCT IS MANUFACTURED.

Pre-Installation

PLANNING INSTALLATION
WARNING: Shut off power at the circuit breaker or fuse
panel before removing the old fixture.
The fixture may not be compatible with all dimmers. If you are unfamiliar with electrical installations, we
recommend you have a qualified electrician do your installation.
Remove the existing fixture. Make yourself a sketch of how the current fixture is wired (by wire color) or mark the
wires with masking tape and a pencil so you will know how to reconnect the wires to your new LED fixture.
ETi SSL Inc. - The Americas Headquarters
720 Corporate Woods Parkway
Vernon Hills, IL 60061
Hardware Included............................... 3
Package Contents ................................ 3
Installation .................................................. 4
Troubleshooting.......................................... 5
Care and Cleaning ...................................... 5
Dimmer Compatibility................................. 6
WARNING: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to Part
15B of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
2
Please contact 1-855-384-7754 for further assistance.
www.ETiSSL.com

Publicité

Table des Matières
loading

Table des Matières