Westinghouse 20V+ Manuel D'utilisation page 12

ASSEMBLY
WARNING: Before assembly, remove the battery from the tool.
CHAIN AND GUIDE BAR ASSEMBLY
1. Unpack all parts carefully.
2. Place the chain saw on a solid, level surface.
3. Use only genuine 8 in Oregon
recommended for guide bar.
4. Slide the chain (7) in the slot around the guide bar
(6). Ensure the chain is in correct running direction
by comparing it to the chain icon on the guide bar, or
referring to the chain direction symbol found on the guide
bar.
5. Remove sprocket cover (5) by turning sprocket fastener (13) counter-clockwise.
6. Fit the chain onto the drive sprocket (16),
so that the guide bar location pin (14) fits
into the guide bar slot (12) and the two
bar locating tabs fit into the keyway of the
opening on the guide bar (15).
7. Assure all parts are seated properly. Make
sure the drive links are fully seated in the
drive sprocket (16), avoiding a kink. If kink
occurs, pick up on the chain at the guide
bar just ahead of the kink and then pull the
kink out. NOTE: Chain should rotate freely and be free of kinks.
8. Fit the sprocket cover (5) and tighten the cover by turning the sprocket fastener knob (13)
clockwise until it is tight.
FITTING THE SAW HEAD
WARNING: Before assembly, remove the battery from the tool.
1. To attach saw head to main handle, align the groove on the outside of the coupling end of the
main handle (22) with the tongue on the inside of the coupling end of the saw head (20).
2. Push the saw head (18) onto the handle and make sure the three connections seat properly.
3. Tighten coupling head (19).
12
chains or those
®
20 21 22
18
13
16 14
19
12
15