Before The First Use; Cleaning And Maintenance - Hotpoint Ariston CM TDC DSL0 Mode D'emploi

it en
13. The container is designed for use with this
appliance. It cannot be used on a range top.
14. Do not clean container with cleansers, steel wool
pads, or other abrasive materials.
15. Do not hang power cord over the edge of table or
counter, or touch hot surface.
16. Do not place the coffee maker on hot surface or
beside fire in order to avoid to be damaged.
17. To disconnect, remove plug from wall outlet. Always
hold the plug. But never pull the cord.
18. Do not use appliance for other than intended
use and place it in a dry environment.
19. Be careful not to get burned by the steam.
20. 16. Do not let the coffee maker operate without
water.
21. Never use the appliance if the carafe shows any
signs of cracks. Only use the carafe with this
appliance. Use carefully as the carafe is very
fragile.
22. Do not set a hot container on a wet or cold
surface.
23. Do not use a cracked container or a container
having a loose or weakened handle.
24. Scalding may occur if the cover is removed
during the brewing cycles.
25. Some parts of appliance are hot when operated,
so do not touch with hand. Use handles or knobs
only.
26. Never leave the empty carafe on the warming
plate otherwise the carafe is liable to crack.
27. Do not set a hot container on a hot or cold
surface.
28. Do not use outdoors.
29. Save these instructions.

BEFORE THE FIRST USE

Check that all accessories are complete and the unit
is not damaged. Add clean water up to maximum level
to brew several times without coffee powder according
to the steps below, and then discard the water. Wash
the detachable parts thoroughly with warm water.
USING YOUR COFFEE MAKER
1. Open the top lid and fill the water tank with
cold drinking water. The water level should not
exceed MAX level as indicated on water gauge.
2. Put the funnel into funnel holder, then place the
filter in the funnel, and make sure it is assembled
correctly.
3. Add coffee powder into filter. Usually a cup of
8
coffee needs a level spoon of coffee powder,
but you may adjust according to personal
taste. Close the funnel holder, a click sound
will be heard when the funnel holder is closed
completely.
4. Insert the carafe on warming plate horizontally.
5. Plug the power cord into the outlet.
6. Pressing the switch down, the indicator will be
illuminated. The appliance will begin working.
Note: during brewing process you may remove the
carafe to serve for duration of not exceeding 30
seconds, and the coffee maker can stop dripping
automatically. If the serve time exceeds 30 seconds the
coffee will overflow the funnel.
7. Upon completion of brewing coffee, that is one
minute later after the coffee stops dripping out,
you can remove the carafe, pour and serve.
Note: the brewed coffee you get will be slightly
less than the water you have added as some
water is absorbed
DO NOT touch cover, warming plate and so on when
operating as they are very hot.
8. When the process is finished, if you do not want
to serve immediately, keep the switch on, the
coffee can be kept warm in the warming plate
for 40 minutes and the appliance will be cut off
automatically after 40 minutes. For an optimum
coffee taste, serve it just after brewing.
9. Always turn the coffee maker off and disconnect
the power supply after use.
Note: Be careful when pouring the coffee out,
otherwise you would be hurt as the temperature
of coffee just finished is high

CLEANING AND MAINTENANCE

CAUTION: Always unplug the product from
electrical outlet and allow the warming plate
to cool completely before cleaning it. Never
immerse the unit or power cord into water or any
other liquid for cleaning
1. Clean all detachable parts after each use in hot,
sudsy water.
2. Wipe the product's exterior surface with a soft,
damp cloth to remove stains.
3. Water droplets may buildup in the area above
the funnel and drip onto the product base during
brewing. To control the dripping, wipe off the
by coffee powder.