Assembling The Customchill™ Drawer - LG LMXS30756S Manuel Du Propriétaire

3
While you firmly keep hold of the front
sides of the drawer, have someone else
remove the basket from the drawer by
lifting it from the rail system.
4
Now disconnect the wire harness
connection at the end of the right rail by
pressing on the tabs on either side. It may
help to use a small, flat-blade screwdriver
to apply pressure to the ends of the tabs
on either side.
5
Hold both sides of the door and lift it to
remove it from the rail system.
Assembling the CustomChill™ Drawer
1
Grasp the door on each side and lower it
into place on the rail system.
2
Reconnect the wire harness to the
connection at the end of the right rail by
aligning the two ends and pushing them
together until you hear a click. The tabs
should snap back into place. Tug gently to
make sure the connection is secure.
NOTE
If you do not reconnect the wire
harness securely, the CustomChill™
drawer will not work properly.
INSTALLATION 19