Specifications - Walter Surface Technologies ICECUT100 Manuel D'utilisation

4) SPECIFICATIONS

ICECUT 100
Maximum hole cutting capacity: 30mm dia. x 35mm deep Arbor
bore = 19.05mm (3/4") dia.
ICECUT 100
Voltage / Frequency
Normal full load
Electro Magnet
Size
Holding Force at 20°C with 25mm
minimum plate thickness
The use on any material less than 25mm thick will progressively
reduce the magnetic performance. If possible, substitute
material should be positioned under the magnet and work
piece to equate to a suitable material thickness. If this is not
possible, an alternative secure method of restraining the
machine MUST be used.
Total Load (magnet + motor)
Overall Dimensions
Height - maximum extended
Height - minimum
Width (including Capstan fitting)
Length Overall (including Guard)
Nett Weight
PRODUCT CODE
Vibration total values (triax vector sum) in accordance with
EN61029-1:
Level of sound pressure in accordance with EN61029-1:
Ear and eye protection must be worn when operating this machine. Wear gloves to protect hands when operating
the machine.
We declare in our sole responsability:
These MAGNETIC DRILLING UNITS comply with all relevant requirements of the directives and standards of CSA.
Do not use your magnetic drill on the same structure when arc welding is in progress.
D.C. current will ground back through the magnet and cause irreparable damage.
WARNING: THIS APPLIANCE MUST BE GROUNDED!
NB: ANY MODIFICATIONS TO THIS MACHINE WILL INVALIDATE THE WARRANTY
DO NOT USE ON D.C. SUPPLY
6
120V 50-60Hz
7 A
0.6A
180mm long 90mm
wide
10,000N
919W
414mm
349mm
165mm
270mm
11.68kgs
39-D 100
Vibration emission value (a
Uncertainty(K):1.5m/s²
Sound pressure(LpA): 87.9 dB(A)
Acoustic power(LwA): 100.9 dB(A) uncertainty(K)：3dB(A)
850 W
69W
):2.273m/s 2
h