Table des Matières
Publicité
2.9 Onboard Headers and Connectors
2.9 Onboard Headers and Connectors
2.9 Onboard Headers and Connectors
2.9 Onboard Headers and Connectors
2.9 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper
caps over the headers and connectors will cause permanent dam-
age of the motherboard!
•
Floppy Connector
(33-pin FLOPPY1)
(see p.2/3 No. 23)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Blue)
(39-pin IDE1, see p.2/3 No. 8)
connect the blue end
to the motherboard
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATA II Connectors
(SATAII_1 (PORT0):
see p.2/3, No. 16)
(SATAII_2 (PORT1):
see p.2/3, No. 13)
(SATAII_3 (PORT2):
see p.2/3, No. 18)
(SATAII_4 (PORT3):
see p.2/3, No. 12)
(SATAII_5 (PORT4):
see p.2/3, No. 10)
(SATAII_6 (PORT5):
see p.2/3, No. 11)
For K10N78-1394, SATAII_6 (PORT5) connector can be used for inter-
nal storage device or be connected to eSATAII connector to support
eSATAII device. Please read "eSATAII Interface Introduction" on page 33
for details about eSATAII and eSATAII installation procedures.
2 8
2 8
2 8
2 8
2 8
ASRock
80-conductor ATA 66/100/133 cable
These six Serial ATAII
(SATAII) connectors support
SATA data cables for internal
storage devices. The current
SATAII interface allows up to
3.0 Gb/s data transfer rate.
K10N78-1394 / K10N78
the red-striped side to
Pin1
connect the black end
to the IDE devices
Motherboard
Publicité
Table des Matières
