Reer Colour SoftTemp Notice D'utilisation page 27

Measurement mode: Object/ambient temperature
If possible, the measurement of liquids should take place from outside the vessel
to avoid any condensation forming on the sensor. The warning indicator is
switched off in this mode. The display is constantly lit in green.
The object/ambient temperature mode shows only the exposure temperature
of the surface/room temperature, and does not provide any indication of body
temperature. This measurement mode cannot therefore be used to measure fever.
Set the regulator to object measurement
temperature measurement. Point the thermometer at the desired object and
press the measure button. Read the measured temperature on the display.
Setting functions
You can adjust the thermometer according to your own particular needs. To do
so, follow these instructions.
Memory function:
. Follow steps 1 to 3 as for body
1. Make sure that the thermometer is switched off.
2. Press and hold the On/Off button for approx.
2 seconds, until the display shows "MEM".
- 27 -