MultiMotion M5 Mode D'emploi page 12

(EN)
The recoil of the back support
Carefully pull the backrest up until it is locked by the locking pins. A clear click indicates that
the back support is locked.
Removing the wheels
This wheelchair is equipped with so-called Quick-release wheels. This means that the wheels
can easily be removed by means of a push button in the axle of the wheel. Press the button
into the shaft and carefully remove the wheel. Hold the wheelchair so that it does not fall
over.
Replacing the wheels
When you put the wheels back, it is important that you keep the button on the axles pressed
when the wheel is pushed over the axle. Check that the wheel is properly secured, if this is
the case it can never come loose unless the button on the wheel axle is pressed again.
Take the wheelchair in the car
The wheelchair can be transported in most cars. By removing the footrests, the wheelchair
becomes smaller.
Use of the brakes
This wheelchair is equipped with brake levers on the push handles. With this the wheelchair
can also be put on the parking position, this is done by squeezing the brakes and pushing the
clip on the start of the brake lever.
Cleaning the wheelchair
It is best to clean the wheelchair with a light household soapy water.
User weight
The maximum user weight is 130 kg.
5
www.multi-motion.nl