Memory Functions - smartheart 01-521 Mode D'emploi

MEMORY FUNCTIONS

Recalling Measurements in Memory
This monitor stores and recalls up to 99 measurements, plus
an average of the last three measurements in each memory
bank / per user.
Select the user to review; see page 10 for instructions on how
to change the User.
All results will be announced aloud in the selected memory
bank if the voice feature is On.
1. Press and release the M button. The unit will first display
the average of the last three measurements, Fig 1.
2. Press the M button again to begin scrolling through the
saved measurements. Measurements will appear on the
display from most current to oldest; the memory number
will appear on the lower right corner of the display, Fig 2.
Press M again to proceed to the result, Fig 3.
3. Press the START/STOP button to turn the unit off.
Clearing Measurements from Memory
Memory for a specific bank may be entirely deleted while in
Memory Recall mode.
1. Press and hold the SET button for approximately 3
seconds to delete all memory records from the selected
group with voice broadcast "Memory Clear" and then
transfer into testing mode, Fig. 3.
2. Press the START/STOP button to turn the unit off.
NOTE: Memory can not be recovered once it has been
deleted.
18 • ENGLISH
mmHg
AVG
M D
Fig. 1
No
M D
Fig. 2
mmHg
M D
Fig. 3