Starting/Stopping The Mower; Led Lights - Scotts 60062S Manuel De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

STARTING/STOPPING THE MOWER

See figure 9-10
To start the mower:
Raise the battery cover (1).
Install battery pack (2).
Insert the switch key (3) into the slot beside the
battery port.
Lower the battery cover (1).
Fig. 9
3
2
Press and hold the safety lock-out button (1).
While continuing to hold the start button, pull the bail
wire (2) toward the handle (3). Once the motor
starts, release the button (1).
Fig. 10
To stop the mower:
Release the bail wire (2).
SOFT-START
This LI-ION mower is equipped with a "soft-start"
feature. When initially starting up, the mower will take
approx. 3 seconds to get up to full speed. If the mower
does not initially start: Remove the battery and check
under the mower deck to ensure there is nothing
obstructing the blade and that the blade can spin freely
by hand. Even a small amount of grass on start up will
prevent the "soft-start" from turning the mower on.
CAUTION: Do not attempt to override the operation of
the safety lock-out button or bail lever.
OPERATION
1
3
5
2
4
1

LED LIGHTS

See figure 10-11
The LED lights (1) are located at the front of the motor
cover. The lights can only be illuminated when the
battery and switch key are installed in the mower and
when the bail wire is engaged.
To turn on, press the LED lights switch button (4). The
lights will illuminate when the bail wire (2) is pulled
toward the handle (3).
When the bail wire (2) is released, the lights will remain
lit for a few seconds before automatically going
out. When the bail wire (2) is engaged again, the lights
will illuminate.
To turn the LED lights off, press the LED switch button
(4) again.
POWER INDICATOR ON THE MOWER
See figure 10, 12
The mower is equipped with a power indicator (5) to
indicate the charge capacity status of the battery pack
and the working status of the mower.
button, LED displays shows the battery capacity.
LED lights
All LED are lit
LED 1, 2, 3 are lit
LED 1, 2 are lit
LED 1 is lit
12
Model 60062S
1
Fig. 11
By pressing the
Fig. 12
Battery status
Full charged (75-100%)
Battery is 50%-75% charged
Battery is 25%-50% charged
Battery is empty (0%-25%).
Charge the battery.

Publicité

Table des Matières
loading

Table des Matières