PULMIC PEGASUS 15
www.gruposanz.es
1. INTRODUCTION AND USES
Read this manual carefully before starting to use the sprayer and pay special
attention to the maintenance recommendations, as well as their use for
correct operation and useful life.
The company reserves the rights to changes the composition of the product
without prior notice as well as its technical characteristics. No claims can be
derived from the data and illustrations in this manual. The original manual
is written in Spanish, so it will prevail over the rest, in case of conflict or
contradictions between other languages.
This sprayer is specially designed for use with phytosanitary products such
as fungicides, insecticides or herbicides. It can be used both for gardening
and small farms. In no case should it be used to spray flammable or industrial
products such as solvents, alkalis or acids.
2. COMPOSITION AND START-UP
Before starting work, you must finish charging the battery (during storage
it may have lost some of its charge). To do this, the battery must be
disconnected from the sprayer.
Plug the charger into the mains and connect it to the battery until it is fully
charged. When the charge level is full, the battery LEDs will stop flashing
and stay on.
The sprayer's operating temperature range is 1 ° to 50 ° C.
To start working with PULMIC PEGASUS 15, press the 3S button with your
left hand and a green light will turn on, the sprayer will start at speed 1
(low pressure) suitable for herbicide treatments, pressing a second time the
indicator light will change to orange light, we will get speed 2 (medium
pressure) suitable for herbicide and insecticide treatments (according to
needs and nozzle used), pressing the indicator for the third time will change
to red light, we will obtain speed 3 (high pressure) suitable for insecticide
treatments. Pressing for the fourth time the indicator light will turn off and
the sprayer will stop. In standby mode, the sprayer will be ready to be used
again when required.
— 10 —