Bresser 88-32000 Mode D'emploi page 13

TIP: If you press just one time, you have already
generated enough power for 30 seconds of light.
You may leave the light on until it goes out on its
own. Then you can just „make" some new electri-
city right away.
After Use
When you are done with your pocket flashlight,
push the drive lever (4) into the casing (7); at the
same time, slide the slide for securing the drive
lever (3) against the direction of the arrow back to
the front.
If the light is still on, you should also push the On/
Off switch (2) back against the direction of the ar-
row. That way, you'll protect the LEDs of your po-
cket flashlight.
Note:
• Press drive lever at a uniform speed. If press too
hard or too fast, the drive system may be damaged
and then affect the service life of product.
• In order to conserve and extend the service life
of inner storage battery, please press drive lever to
charge the battery when the light begins to fade.
• In order to conserve and extend the service
life of inner storage battery, it is recommended
that you press the Drive lever at least once each
month and not exceed 10 minutes each time.
Please make sure the power is turned off during
idle period.
• Don't storage the product in a high temperature,
high humidity and dusty place. Collision and high
impact or vibration should be avoided when you
use it.
GB
13