Installing Software - 3com AirConnect 9550 Guide De Mise En Route

5. Checking the LED Indicators
When the AP is connected to power, LEDs indicate activity as follows:
Indicator
LED 1
(Power/
System)
LED 2
(2.4G)
LED 3
(5G)
(on the 3Com
AirConnect 9550
Access Point only)
LED 4
(Ethernet)

6. Installing Software

The following application is included on the 3Com WIDMan Utility CD-ROM:
•
Wireless Infrastructure Device Manager (WIDMan Utility)
To discover and configure the AP, you must first install the Wireless Infrastructure Device Manager
software (WIDMan) on your computer.
1
Turn on your computer.
2
Insert the 3Com Installation CD into the CD-ROM drive.
The CD menu appears. If it does not appear, start the Setup menu from the Windows Start
menu. For example: Start > Run > d:\autorun.exe
3
On the menu, click Install/Uninstall WIDMan.
4
On the next screen, double-click 3Com Wireless Infrastructure Device Manager and then
click Install. The installation begins.
5
Follow the instructions on each screen to complete the installation. If prompted, reboot the
computer.
Color State
Off
Amber On
Blinking
Green On
Green Off
On
Blinking
Green Off
On
Blinking
Off
Amber On
Blinking
Green On
Blinking
8
Description
No power
Failure of CPU or system
System initiation or reset (software self-
testing and loading)
Powered on and ready for operation
Radio disabled
Radio enabled
Activity
Radio disabled
Radio enabled
Activity
No 10/100/1000 BASE-T link detected, or
administratively disabled
10/100 BASE-T link detected; no activity
10/100 BASE-T link activity
1000 BASE-T link detected; no activity
1000 BASE-T link activity