Transport; Connecting To Power Supply - Belle TUBMIX 50 Mode D'emploi

GB

5. Transport

The machine is easy to move. Lift the handle and
move the machine on its wheels, as shown in Fig. 8.
8

6. Connecting to power supply

Make sure that the switch is turned off before inserting
the plug.
The machine is to be connected to the power supply by
a residual current circuit breaker (RCCB) or class
II isolation transformer with the following
characteristics:
RCCB
230V
In 10 A Id 20 mA
115V
In 20 A Id 20 mA
N.B. To ensure correct functioning, periodically
the push-button on the front of the same.
Prior to connecting the machine to the power
supply, make sure that the voltage is the same as
indicated on the machine data plate. The machine
must be connected to an effective earth wire. In
case of doubt, do not connect the machine.
INFORMATION
Please be aware that when the mixing head and
agitator are raised out of the mixing tub an automatic
safety switch is engaged preventing the operation of
the motor.
Transformer
230 V 50 Hz 1500 W
Cont. duty
115 V 50 Hz 1500 W
Cont. duty
THE MOTOR SHOULD ONLY BE RUN IN THE
MIXING POSITION WITH THE AGITATOR
POSTIONED WITHIN THE MIXING TUB.
The TUBMIX are provided also with overheat
protection with manual reset. This intervenes in the
event of the agitator jamming. In the event of
it jamming, before resetting the thermal protection,
disconnect the machine from the mains electricity
supply and empty the basket partially.
9
7. Preparation of the Mixture
Proceed as follows to prepare the mixture:
Always start the machine only when it is empty.
Proceed as follows or as directed for the type of
material to be mixed.
CAUTION!
A) Carefully read the instructions on the glue sack
you are going to use.
B) Pour in the tub the quantity of water necessary to
prepare the desired adhesive quantity
following the manufacturer's instructions.
C)
powder at a speed of 10 kg/min directly on the
plastic protection, which will centrifuge the material
to obtain an appropriate mixture.
Continue with this operation in a continuous and
uniform manner with the second sack (25 kg) and
wait for the whole product to be properly mixed. In
this way the mixture will be free from lumps.
6