Belle TUBMIX 50 Mode D'emploi page 7

minutes and then mix it again for few minutes.
The machine may be moved to the position
where the adhesive is to be used.
Cement
and plaster containing lime, cement, gypsum and
concrete or mortar containing medium-large sized
gravel or aggregates.
in order to prevent excessive hardening of the
compound, a great deal of attention must be paid to
the addition of lime, cement, gypsum or aggregates
when nearing the end of the mixing process.
Epoxy resins
density of the products to be prepared, so that the
mixer motor is not overloaded.
any powders indicated by the product supplier.
forming in the mixture.
Paints
add the necessary amount of water required for
the solution.
CAUTION!
! The use of chemical products or solvents may
affect the properties of the tub, made of high
density polyethyiene PET.
! Check the compatibility of the products to be
mixed with the properties of the machine before
use.
8. Maintenance
The machine's reduction unit is lubricated with
lubrication of enclosed gears in casings.
When changing the grease, use only products with the
characteristics listed below:
NLGI Degree:
Dropping point: °C
Thickening agent
CAUTION!
To change the grease, contact your local dealer.
9. Disposal
In the event of the tub becoming worn or damaged,
it must be disposed of in accordance with the
methods laid down by current legislation.
In the event of scrapping the complete machine, it
must be disposed of in accordance with the
methods laid down by current legislation.
Electric Motor
Aluminium
Steel
Copper
Poiyamide
Machine's Framework
Steel
Poiyamide
Tub
Polyethylene
7
GB
0
115
SODIUM SOAPS
PET
AL
AC
CU
PA
AC
PA