Getting Started; Battery Charging; Navigation On Your Camera - TnB SPCAMXP30 Mode D'emploi

EN FR

GETTING STARTED

Welcome to the user manual for your new XP30 camera!

Battery charging

To optimise the use of your camera, charge the battery fully before first use.
To do so, connect the camera to a computer or any other USB charging adapter
using the micro USB cable provided. The micro USB port is located inside the
camera body. A message appears on the screen to inform you that the camera
is connected to the computer. A white LED comes on at the back of the camera.
A message appears on the screen when the battery is fully charged.
The charging time of the camera is about 2 hours. It is normal for the camera to
heat up slightly while charging.
Note: You can also charge your camera using a USB compatible T'nB wall
charger or car charger (sold separately).
MicroSD card
A microSD card (sold separately) is required to capture videos and photos. Use
branded memory cards that meet the following specifications:
- MicroSD, microSDHC or microSDXC
- Class 10 or UHS-I
- Minimum capacity of 8 GB, maximum of 64 GB
Note: Handle memory cards with care. Turn off the camera before inserting or
removing the card. Consult the memory card manufacturer's instructions for
more information.
Inserting the microSD card
To insert a microSD card, open the camera body
using the opening system on the edge. Remove
the battery to access the microSD card slot, which
is located below the battery. Slide the door up to
unlock access to the micro SD card slot. Insert your
micro SD card. Slide the door down to lock.
Formatting the microSD card
For best use, format the microSD card before first use. To keep the card in good
condition, format it regularly.
Note: formatting erases all the content on the card, so be sure to transfer your
photos and videos beforehand
17
To format the card, press the button four times. Then press once on
press 3 times again to navigate through the settings until you reach the
general settings. Press «Format» and then «Confirm». To exit this menu, press on
until you reach and then press again on
Powering on and off
To turn on the camera
Hold down the button for 4 seconds. The opening screen appears and a
white LED lights up at the back of the camera.
To turn off the camera
Hold down the button for 3 seconds. The closing screen appears and the
white LED at the back of the camera goes off.
Navigation screen
The display shows the following information about modes and settings. The
displayed settings vary depending on the mode.
1
4K30FPS 14.6G
2
3
2017/01/01 00:03:12
1. Video/Photo/Playback Mode
2. Resolution
3. Microphone on/off
4. Remaining space on
the memory card

NAVIGATION ON YOUR CAMERA

The XP30 camera has three modes: Video, Photo, Slow motion.
Video
Three capture modes are available in Video mode: Video, TimeLapse, Loop
Recording. These modes will be explained later in this manual.
, then
to confirm.
4
5
6
TF
7
5. Memory card
6. Battery status
7. Date stamp
18