Part Identification; Tools Required; Materials Needed - Homestyles 73005129 Manuel Du Propriétaire

Part Identification
Base Track Floor Panel
(AL1-AL4)
Left Gable
(GHL)
Roof Panel A Roof Panel B
(RPA) (RPB)
Ridge Beam Cap Ridge Beam Joint Cover
(RB1)
Door Window Glass Door Window Seal
(DWG) (DWS)
Handle Latch Striker Door Handle Collar
(DHLS) (DHC)
Back/Side Wall Panel
(FT1)
Right Gable Window Frame
(GHR) (WF1)
Roof Panel C Shed Tie Strap
(RPC) (RTS1/RTS2)
Ridge Beam End Cap
(RBJC) (RBEC)
Door Hinges
(HA4)
Door Handle Spacer
(DHS)
7
(WP1/WP2)
Window Gable Glass
(WGG)
Shed Center Truss Tube
(SCTT)
Door Panel
(DP1/DP2)
Decorative Hinge Cover Door Handle Lever
(HDT)
Handle Mounted Hasp Door Handle Washer
(DHH)
Front Wall Panel Corner Post
(WP3) (CN1)
Gable Vent Door Lintel
(VN1)
Ridge Beam End Plate Ridge Beam
(RBP) (RS1/RS2)
Door Astragal
(ASTA)
Handle Steel Insert
(DHL) (DHSI)
Door Lock
(DHW) (LK)
Door Jamb
(VDJ)
Wall Cap
(LT1/LT2) (SC1)
Ridge Beam Insert
(RBS)
Spacer
(SPC)
Door Handle Base
(DHP)

Tools Required

®
• Power drill with Phillips (#2)
or a #2 Robertson bit • Level
• Safety glasses • Rubber mallet
• 5/16" & 9/64" Drill Bit • Gloves
• Measuring Tape - Min. 16' feet (5m)
Phillips is a registered trademark of PhillipsScrew Co.

Materials Needed

• Silicone Caulking