Publicité
Les langues disponibles
Les langues disponibles
Properties of the Viroxid
Habitat 3:
®
• Suitable for areas up to 100 m
• Adjustable to 25 m
or 50 m
3
3
• Reduced noise level
• Replacement of the UV-C lamp and filter once a year
• The unit indicates when the lamp and filter should be replaced
• Up to 50% more UV-C yield as a result of reflection
in the aluminium housing
• Simple installation and maintenance
• Stand-alone system and immediately ready-for-use through
"plug and play"
• 2-year guarantee on manufacturing faults
The Viroxid
Habitat 3 is effective against:
®
• Viruses
• Bacteria
• House-dust mites
• Dust and particulates • Pollen
• Cigarette smoke
• Harmful gases
The Viroxid
Habitat 3 is recommended for the following areas:
®
• Schools
• Day-care centres
• Nursing homes
• Hotels
• Copying areas
• Doctor's surgeries
• Veterinaries
• Animal shelters
• Lounges
• Bedrooms
• Computer rooms
• Studies
• Holiday homes
• Caravans
• Fitness areas
• Smoking areas
• Hairdressers
• Beauty parlours
• Pubs
• Meeting rooms
Safety
This device produces harmful radiation. Direct contact could impair
the eyes and skin. Only check the operation of the UV-C lamp through
the air vents at the top of the unit. The openings will light up blue if
the lamp is on.
• When switching on the device for the first time, you may notice a
burning smell from the UV-C lamp for a short time. This odour is similar
to the odour you notice when using a sun bed, and will disappear
after a short time.
• Always comply with the electricity company's regulations with re-
gard to any permanent connection to the mains. If there is any doubt
regarding the connection, consult a recognized electrician or the
electricity company. Always work with an earth leakage current cir-
cuit-breaker (residual current trip).
• Always remove the plug from the socket before carrying out any
maintenance or repair work on the unit. Never insert the plug / pull
the plug from the socket when you are standing in water or if your
hands are wet.
• Never submerge this device in water.
• Never install the unit in an area subject to full sunlight.
• Keep children away from this device and from the cable.
• The cable of the device cannot be replaced. The complete unit
must be replaced if there is any damage to the power cable. Nev-
er remove the plug, but always leave the electrical unit intact. An
electrical unit with the plug removed will no longer be covered by
the guarantee.
• Once the device has been switched off, the lamp will remain hot for
approximately 10 minutes.
• Do not use the device if any of the components are damaged.
• This product can only be used according to the guidelines described
in these instructions for use.
v
iroxid
®
GB
Manual Instructions
HABITAT 3
3
air per hour
• Moulds
• Odours
• Old people's homes
• Offices
• Dental surgeries
• Kennels
• Hobby rooms
• Play rooms
• Boats
• Restaurants
• Public toilets
• Dressing rooms
Installation of the device
Determine where the device will be installed.
When selecting a location for the device,
please bear in mind that the unit must be able
to circulate the air in the room freely
and without obstructions.
Also ensure that there is a power socket near
the selected location.
Install the device in a dry place.
Ideally, the unit should be mounted in the vertical position, with a free
space of at least 50 cm underneath for carrying out maintenance and
for the replacement of the filter and/or UV lamp.
1. Remove the clips (A) (see Drawing 2) from the AIR160 by unscrewing
the cover (M) (see drawing 5) and position the clips (A) at the select-
ed location so that you can mark where the clips should be fitted
onto the solid back wall.
2. Fix the clips at the selected location with suitable screws and/or
plugs (see Drawing 2).
3. Place the AIR 160 in the fixed clips in the hinge and place the brack-
ets into its place (see Drawing 3, 4). Finally screw the cover on the
clips (see drawing 5).
4. Insert the plug into the socket and check the operation of the UV-C
lamp (H) - only do this through the air vents at the top of the unit! Blue
light can be seen through the air vents of the lid (I) if the lamp is on
(see Drawing 1).
5. Check the operation of the ventilator (K) by holding your hand un-
derneath the filter grid (C). If you feel an air flow, the ventilator (K) is
working (see Drawing 1).
Keys
5
sec
7
press briefly
press for 3 sec.
wait 5 sec.
selection confirmed
lamp operating time
real-time clock
test
air circulation, low position
air circulation, high position
set clock
reset
fail
Publicité
