Set Back; Humidifier And Air Flow Direction; Adjusting Air Flow Direction - Rinnai Energysaver EX38C Manuel D'utilisation

Set Back

This function allows a minimum room temperature to be pre-set, between 38ºF
and 78ºF (in 1ºF increments). This temperature should be set below the room
temperature setting. The default setting is 60ºF. Once the Set back function is
selected the appliance will start heating whenever the room temperature falls
below the selected temperature, regardless of timer or manual settings.
Follow these steps to set and operate the Set back feature:
1. Make sure the heater is turned OFF.
2. Press the "Set back" button. The light above the button will come on.
3. Press the up and down buttons to set the minimum temperature.
When the "Set back" indicator is on, frost protection is operating, and will always
prevent the room temperature from falling below the pre-set minimum
temperature (as long as electric power and gas is supplied).
To turn this feature off, press the "Set back" button.
The unit will retain its ON or OFF setting after a power failure. (Set Back feature
is on by factory default.)

Humidifier and Air Flow Direction

Adding Water to the Humidifier
CAUTION
To fill the tray, open the door as shown in the diagram
and pour water into the tray using the spout built into
the door. The air will be humidified as it passes over
the water in the tray.
During operation a small amount of condensation is
produced in the flue system and drains into the
humidifier tray.
If the water overflows from the water level hole, then
do not add any more water.
Humidifier Tray
Max. Fill Line
10
Do not fill the tray while the
appliance is in operation.
Close the door after filling.
The humidifier tray and
surrounding area are hot
when the appliance is on.
Access Door
Pull
Filler Spout
Do not force door open too far.
Close door during operation.
Rinnai Corporation EX38C Manual

Adjusting Air Flow Direction

CAUTION
The vertical louvers may be adjusted to move the air
flow more to the right or to the left.
Use a screw driver or similar object to bend each
louver to the desired position.
Do not bend repeatedly (no more than 5 times) or else
the louver will break.
The horizontal louvers (which determines the vertical
air flow direction) are fixed and cannot be adjusted.
Do not adjust the air flow
louvers while warm air is
flowing.