Hama TS35C Mode D'emploi page 8

• You can position the measuring station on a level outdoor surface
using the base.
• We recommend installing the measuring station securely on an
outdoor wall.
• Install an anchor, screw, nail, etc. in the wall of your choice.
• Hang the measuring station using the opening intended for this
purpose (4).
6. Operation
6.1. Connection to the measuring station
• To connect the base station and the measuring station, place the two
devices as close together as possible.
• After you insert the batteries, the base station automatically searches
for a connection to the measuring station and performs initial setup.
• If the device does not connect automatically, the manual search
program on the base station must be started.
Note
• Initial setup takes approximately 5 minutes.
• During the connection attempt, the radio symbol and the LED
indicator (1) on the measuring station will flash.
• Do not press any buttons during setup. Otherwise, values may
not be transmitted correctly and there is a risk of value errors and
inaccuracies.
• The setup process is completed when the indoor and outdoor
measurement data is displayed on the base station.
• The measured value is automatically updated by the base device
about every 60–64 seconds.
7