Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
E
Getting Started
N
G
•
Eye protection designed for paintball use must be worn by the user and any person
L
within range.
I
•
Do not disassemble this marker while it is pressurized.
S
H
•
Do not pressurize a partially assembled marker.
•
Read each step completely before performing the step. The following instructions
are for both X7 Phenom models (Electro-pneumatic and Mechanical) unless
specified otherwise in the step's heading.
: Carefully hand start all threaded parts when assembling, and do not overtighten, as
NOTE
this may potentially strip the threaded parts. Refer to the Parts Diagram on pages 26 and 27
for these instructions (item numbers are in parentheses).
Install the air supply and load the hopper with paintballs only after you:
•
have a barrel blocking device installed (see page 4)
•
have the Selector Switch in Safe mode (see page 6).
Eye protection designed for paintball use must be worn by the user
and any person within range.
1. Battery Installation
NOTE: This marker can be fired in the mechanical mode (F)
without a battery.
To install the battery:
a. Remove the battery door (34) from the back of the grip
by pulling up and back on the tab as shown in Figure
2. NOTE: Whenever removing the battery clip from the
battery, never pull it by the wires.
b. Install a 9 volt battery onto the battery clip.
c. Insert the battery into the grip with the battery clip at the
top, and wires routed as shown in Figure 3.
d. Replace the battery door with the tab down, press the
door and listen for the click as it locks into the grip.
2. Air/CO2 Cylinder Installation
Read the
Air/CO2 Cylinder Warnings, Safety Tips, and Removal
beginning the cylinder installation. Do not pressurize a partially assembled paintball marker.
a. Put the Selector Switch in Safe mode (see page 6) and install the barrel blocking
device (see page 4).
b. Lubricate the air/CO2 cylinder valve O-ring with a little Tippmann grease.
c. Insert the air/CO2 cylinder valve into the Air Supply Adapter (ASA) (35) at the back
end of the marker grip.
d. Twist the air/CO2 cylinder clockwise into the ASA until it stops. Use caution as the
marker is now capable of firing after you put the Selector Switch in a Fire mode. If
you do not hear the full air/CO2 cylinder engage, the pin valve could be too short or
the pin valve seal is damaged, follow the
WARNING
(Electro-pneumatic model)
8
Figure 2: Open Battery
Door
Figure 3: Install 9 Volt
Battery
on pages 12-14 before
Air/CO2 Cylinder Removal
instructions
Publicité
Chapitres
Table des Matières
