Hama RC 540 Mode D'emploi page 10

Stopping the alarm/snooze function
• If the alarm is activated, it is triggered at the set time and an alarm signal sounds
for one minute. The alarm automatically stops after this time and is then triggered
again the next day at the set alarm time.
• To stop the alarm early, move the ALARM ON/OFF slide switch (11) to the OFF
position to the right until the surface underneath the slide switch is black. The alarm
is now deactivated.
• Move the ALARM ON/OFF slide switch (11) back to the ON position on the left
again to activate the alarm for the next day.
Note – Snooze function
• While the alarm signal is sounding, press the SNOOZE/LIGHT button (6) to
activate the snooze function. The alarm clock icon (B – 11) on the display (1)
begins to flash. The alarm signal will be stopped for 5 minutes, after which it
will sound again.
• The snooze function can be activated four consecutive times.
5.4. Temperature display
• Press the RCC button (10), to switch the temperature display (B – 6) between °C
and °F.
5.5. Backlight
• If you press the SNOOZE/LIGHT button (6), the display (1) will light up for approx.
5 seconds.
• The alarm clock is equipped with a twilight sensor (7) that automatically switches
on the backlight of the display (1) to a dimmed setting as soon as it gets dark.
• During the day or if there is enough light, the twilight sensor (7) automatically
switches off the dimmed backlight on the display (1).
• Move the ON/OFF slide switch (8) to the ON or OFF position to activate or
deactivate the twilight sensor (7).
9