Petra electric FSB 1 Mode D'emploi page 6

macist should be used.
In principle, applications for supporting the
therapy should be agreed with the doctor in
attendance.
In any case consult your doctor in the follo-
wing cases:
- feverish illness
- serious diabetes
- skin injuries, skin illness
The wholesomeness of vibration massages
can be restricted by persons who react sensi-
tively to vibrations.
In case all pieces of advice are observed no
side effects are known which go beyond the
known risks of normal foot bathes.
Cleaning and maintenance
Prior to cleaning unplug the appliance. Then
pour out the water using the spout of the
appliance. Do not immerse the appliance in
water. Use a mild cleaning agent with water to
clean the appliance. The hollows on the inner
base part can be cleaned with a soft brush or
with a tablet usually used for cleaning dentu-
res according to its usage instructions. Do not
use caustic or scouring agents.
The air outlet nozzles should be occasionally
decalcified in order to prevent their furring up.
To do so use commercial if possible ecologi-
cally friendly decalcifying agent according to
the manu-
facturer's instructions. Rinse the appliance
with clear water afterwards and pour out the
water only at the spout.
Bath oils
The bath oils which can be delivered as
accessories have especially been developed
for the cosmetic use in hydromassages for
feet or to enrich the air in the room. The active
substances are treated in a basis which is
kind to the skin. They have a greasy effect
and groom the skin. Beside the cosmetic effect
the room is filled with an agreeable perfume.
You can get the following scents either there
where you have bought the appliance or you
can order them directly at the manufacturer:
- pine essence
- hay flower
- rosemary
- balm
6
- lavender
- horse chestnut
Technical data
Voltage
Consumption
Safety class
For UK use only
• This product is supplied with a 13 A plug conforming
to BS 1363 fitted to the mains lead. If the plug is
unsuitable for your socket outlets or needs to be
replaced, please note the following. If the plug is a
non-rewireable one, cut it from the mains lead and
immediately dispose of it.
Never insert it into a socket outlet as there is a very
great risk of an electric shock.
• The replacement of the plug at the mains lead has to
be done according to the following instructions:
Important: The wires in this mains lead are coloured
in accordance with the following code:
blue: Neutral
brown: Live
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug,
proceed as follows:
- the wire which is coloured blue must be connected to
the terminal which is marked with the letter N or
coloured black,
- the wire which is coloured brown must be connected
to the terminal which is marked with the letter L or
coloured red.
Do not connect any wire to the terminal which is
marked with the letter E or by the earth symbol
coloured green or green and yellow.
• If a 13 A (BS 1363) plug is used it must be fitted with a
3 A fuse conforming to BS 1362 and be ASTA
approved. If any other type of plug is used, the
appliance must be protected by a 5 A fuse either in the
plug or adapter or at the distribution board.
If in doubt - consult a qualified electrician.
• Never use the plug without closing the fuse cover.
The appliance complies with the Euro-
pean directive 93/42/EEC.
At the end of its lifetime this product must not be
disposed of through the normal domestic waste,
but it should be handed to an assembly point for
the recycling of electrical and electronical appli-
ances. You can inquire about details at the local
administration.
Subject to technical changes.
230 V 50Hz
100 W
II
, or