Zephyr Essentials Genova ZGE-E30AS Guide D'utilisation, D'entretien Et D'installation page 8

2 4
3 2
3 6 "
DUCTING
A minimum of 6" round ducting must be used to
maintain maximum air f ow eff ciency.
Always use rigid type metal ducts only. Flexible
ducts could restrict air f ow by up to 50%.
Use calculation worksheet to compute total duct
work.
ALWAYS, when possible, reduce the number of
transitions and turns. If a long duct run is required,
increase duct size from 6" to 7" or 8".
If turns or transitions are required: Install as far
away from opening and as far apart, between 2,
as possible.
Mounting height from top of cooking surface to
bottom of hood should be no less than 24" and no
more than 32".
It is important to install the hood at the proper
mounting height. Hoods mounted too low could
result in heat damage and f re hazard while hoods
mounted too high will be hard to reach and will
lose performance and eff ciency.
If available, also refer to range manufacturer's
height clearance requirements and recommended
hood mounting height above range. Always check
i n .
" m
your local codes for any differences.
a x .
" m
DAMAGE-SHIPMENT / INSTALLATION:
• Please fully inspect unit for damage before
installation.
• If the unit is damaged in shipment, return the
unit to the store in which it was bought for
repair or replacement.
• If the unit is damaged by the customer, repair
or replacement is the responsibility of the
customer.
• If the unit is damaged by the installer (if other
than the customer), repair of replacement must
be made by arrangement between customer
and installer.
6
www.zephyronline.com