Table des Matières
Publicité
7422 Thermal Printer User's Guide
Threading the
Optional Label
Peeler
Step
Step
Step
Step
30
If you would like the printer to
automatically peel adhesive labels from the
backing, follow the steps below:
Perform steps 1-4 of the Loading Labels
procedure.
Peel the first two labels off the backing.
While pressing the FEED switch, push the
label backing into the peeler slot.
Pull the label backing out the bottom slot
until it is tight across the peeler bar.
Activate the Label Taken Sensor by
pressing in on the top of the sensor.
Publicité
Table des Matières
Dépannage
