Samsung DW80K7050 Série Manuel D'utilisation page 28

troubleshooting
PROBLEM
Leaves glasses with
a dim polish.
Leaves a yellow
or brown fi lm on
the inside of the
dishwasher.
Does not dry dishes
well.
Has a bad odor.
Is too noisy.
POSSIBLE CAUSE
The water supplied is soft and too
much detergent was used.
Aluminum dishes were included in
the wash load.
This is caused by coffee and tea
soils.
There is no rinse aid in the
dispenser.
The temperature of the water
is low when the dishwasher is
running.
Too many dishes have been
loaded.
Glasses and cups with concave
bottoms hold water. This water
may spill onto other items when
unloading.
AutoRelease™ Dry mode is not
in use.
Water was left over from an
incomplete cycle.
The Drain Hose is obstructed.
The dishwasher is not used daily
or soiled dishes are left in unit too
long.
Sound is generated when the
dispenser cover is open and the
drain pump is operating in an early
stage.
The dishwasher is not level.
Foreign material (a screw, a plastic
piece) is in the pump chamber.
There is a 'chopping' sound
because a nozzle is bumping
against the dishes.
English - 28
SOLUTION
Underload the dishwasher and use a rinse
aid to minimize this.
Remove the marks on the dishes using a
low sensitivity cleaner.
Remove the soils using a spot cleaner.
Check the dispenser and add rinse aid.
Use a liquid type rinse aid.
Connect the water supply line to a hot
water supply.
Use rinse aid with the Sanitize option.
Proper loading of items can affect drying.
Load your dishes as recommended. (See
page 16.)
After the cycle fi nishes, empty the lower
rack fi rst and then the upper rack. This will
prevent water from dripping from the upper
rack onto the dishes in the lower rack.
Activate the AutoRelease™ Dry mode. (See
page 12.)
Insert detergent without loading dishes,
and run the Normal cycle to clean the
dishwasher.
Contact a qualifi ed service technician to
remove any obstruction from the drain
hose.
With the dishwasher empty and no
detergent, place a glass with 8
ounces of vinegar upright into the lower
rack, and then run a Normal
cycle.
This is normal operation.
Ensure the dishwasher is level.
Contact a qualifi ed service technician to
remove foreign material from the pump
chamber.
Rearrange the dishes.