Energeeks EG-CIPBAT001 Guide D'installation Rapide page 19

•
Show the camera the QR code that appears on the screen,
placing the screen a few cm from the lens and slowly moving it
away to a distance of about 30 - 40 cm, if you do not recognize
the QR code, continue showing it by slowly zooming in and out
until you hear the confirmation phrase and press continue.
•
The installation will finish automatically and the camera will
be displayed.
Connection failure: If after reading the QR code the installation
process fails, make sure you are connected to a 2.4 GHz Wifi network
and that the provided password is correct.
Some fiber optic routers have an inappropriate configuration for this
system, if after following these steps the camera does not connect,
contact our technical service, who will advise you to configure it
correctly.
Speaker
Status light
Microphone
Lens
Photosensitive
PIR
Reset
Micro USB
Charging indicator
Power button
SD card slot
19