Energeeks EG-CIPBAT001 Guide D'installation Rapide page 18

Quick Installation Guide
Before starting...
For the Wifi connection, the camera only supports the 2,4Ghzhz
frequency, (it does not support 5Ghz), it is necessary to connect the
installed phone to the 2,4Ghz network (only during the installation
process), once the camera is installed you can reuse 5Ghz.
Instalación
•
Turn on the camera by pressing and holding the power button
for 3 seconds.
•
The camera will beep indicating that it is ready to connect.
•
Connect your phone to the 2,4Ghz network and open the
application "Energeeks 3.0"
•
Press the + sign at the top to add a new device and select
surveillance camera.
•
In the first step, the application asks you to reset the camera
so that it starts in connection mode, to do this, press and hold
the reset button for 5 seconds. In the application confirm and
go to the next step.
•
Enter the password for the Wi-Fi network and press confirm.
Make sure the Wi-Fi network shown in the application is your
2.4Ghz network.
18