Ayce C2065A Manuel D'utilisation page 91

Receiving wireless signal after
manual reset or [ SENSOR ] key
is pressed
When waiting for signals, " --"
will display in readings field
Fair wireless sensor signal
The 4th row display
1.
In normal mode, the 4th row display will show indoor "IN" data. Press
[ CHANNEL / + ] key repeatedly to switch to outdoor channel CH 4~8.
In normal mode, press and hold [ CHANNEL / + ] key for 2 seconds to
2.
toggle auto-cycle mode, which alternately displays the channels at 4
second intervals. The "
During auto-cycle mode, press [ CHANNEL / + ] key onceto stop.
3.
To check the validity of the signals of CH 6~8, press [ CHANNEL
4.
/ + ] key repeatedly in normal mode to display each channel. Using
auto-cycle mode will only display the communicated channels.
For example, when CH 6 and 8 have received the signals from the
corresponding sensors, you can press and hold [ CHANNEL
/ + ] key for 2 seconds to auto-cycle INDOOR, CH 6 and 8's
display.
" icon will show on the display.
90 | 91
GB