Dyson supersonic HD01 Mode D'emploi page 4

persons in order to avoid
a hazard.
6. This appliance has a non-
self resetting thermal cut
out safety device to prevent
overheating. If your appliance
cuts out, unplug it from the
mains supply socket and
leave to cool.
7. CAUTION: In order to avoid
a hazard due to inadvertent
resetting of the thermal
cut-out, this appliance must
not be supplied through an
external switching device,
such as a timer, or connected
to a circuit that is regularly
switched on and off by the
utility company, or plugged
into any socket where the
electrical supply is unstable or
likely to be turned off.
8. For additional protection,
the installation of a residual
current device (RCD) having
a rated residual operating
current not exceeding
30 mA is advisable. Ask your
installer for advice.
9. Do not use the appliance
for any other purpose than
drying hair.
10. Do not handle any part of
the plug or appliance with
wet hands.
11. Do not unplug by pulling on
the cable. To unplug, grasp
6
the plug, not the cable.
The use of an extension cable
is not recommended.
12. Do not stretch the cord or
place the cord under strain.
Keep the cord away from
heated surfaces and do
not wrap the cord around
the appliance.
13. Do not use any lubricants,
cleaning agents, polishes or
air fresheners on any part of
the appliance.
14. Contact the Dyson Helpline
when service or repair is
required. Do not disassemble
the appliance as incorrect
reassembly may result in an
electric shock or fire.
15. If the appliance is not
working as it should, has
received a sharp blow, has
been dropped, damaged,
left outdoors, or dropped into
water, do not use and contact
the Dyson Helpline.
The air exit, metal ring, attachments
and area shaded in red may be
hot during use. Allow them to cool
before handling.
7