PROBLEM
Shuts off before load is dry
Lint on clothes
Garments still wrinkled after
Wrinkle-Care
Odors remain in clothing
after Refresh.
Water drips from nozzle
when Steam-Care starts
Sprayed water is not visible
during Steam-Care
DV455-02836F_EN.indd Sec6:49
DV455-02836F_EN.indd Sec6:49
SOLUTION
•
Dryer load is too small. Add more items or a few towels and restart
the cycle.
•
Dryer load is too large. Remove some items and restart the dryer.
•
Make sure the lint fi lter is cleaned before every load. With some loads
that produce high amounts of lint, it may be necessary to clean the
fi lter during the cycle.
•
Some fabrics are lint producers (for example, a fuzzy white cotton
towel) and they should be dried separately from clothes that are lint
trappers (for example, a pair of lack linen pants)
•
Divide larger loads into smaller loads for drying
•
Check pockets thoroughly before washing and drying clothes.
•
Small loads of 1 to 4 items work best.
•
Load fewer garments.Load similar-type garments.
•
Fabrics containing strong odors should be washed in a normal cycle.
•
This is steam condensation. The dripping water will stop after a short
time.
•
Sprayed water is diffi cult to see when the door is closed
Troubleshooting _49
2012-03-21
2012-03-21
1:25:09
1:25:09