Technical Data; Back Up Battery - Ayce TH-928T Manuel D'utilisation

TECHNICAL DATA

Model
Voltage
Frequency
Power
Protection Class
Construction of control
Number of automatic cycles
Features of automatic action
Control pollution degree
Rated impulse voltage
Temperature for the ball pressure test
of accessible parts
Contact details for obtaining more
information
OPERATION
CONTROL PANEL
3
2
1
6
8
TH-928T
230 V~
50 / 60 Hz
2300 W
I
Integrated control, electronic
control
6000 cycles
Type 1 action, 1.B
Pollution degree 2
2500 V
75°C
Jumbo-Markt AG
Industriestrasse 34, 8305 Dietlikon,
Tel. +41 848 11 33 11
1 RM: environment temperature
2 Heat up: flame sign
Work state indicator light: quench,
4
3
red, green
4
Refrigeration: Snowflake Sign
5
5
SET: select temperature
6
UP
7
7 DOWN
8
9 PWR
9
RESET
1. When is at OFF mode, press PWR and UP button simultaneously for about 3
seconds to switch between heating and cooling.
2.
Press UP and DOWN button simultaneously for about 3 seconds to switch
between °C and °F.
3. Default status:
Default SET Temperature: 20°C.
Default Mode: Heating
4. Setting:
4.1 Press the Power button (PWR) to set the value of temperature.
Note:
Operating Temperature: -10°C ~ 40°C.
Temperature Control range: 5°C (40°F) ~ 30°C (85°F);
Precision: ±1°C;
Measuring period: 10 S.
4.2 Cooling(Snowflake)：
A.
Press "UP" or "DOWN" repeatedly, set "SET" temperature at least 2℃ lower
than "RM" temperature. After 1-3 minutes, LED will turn green, outlet will turn
on.
B. When "RM" temperature reaches "SET" temperature, LED will turn red and
snowflake will disappear, outlet will turn off.
C. When "SET" temperature is higher than "RM" temperature, LED will display
red and outlet will turn off.
4.3 Heating (Flame):
A. Press "UP" or "DOWN" repeatedly, set "SET" temperature at least 2℃ higher
than "RM" temperature. After 1-3 minutes, LED will display green, outlet will
turn on.
B. When "RM" temperature reaches "SET" temperature, LED will turn red and
flame will disappear, outlet will turn off.
C.
When "SET" default temperature is lower than "RM" temperature, LED will
display red and outlet will turn off.
4.4 Reset – Press the reset button with a pin to restore default setting.

BACK UP BATTERY

Unit provide a Lithium back up battery CR2032.
When the LCD displays "LO". Replace the battery at the battery compartment at the
back of the unit.
34 | 35 GB