Publicité
Les langues disponibles
Les langues disponibles
RADIO-CONTROLED LED ALARM CLOCK
INSTRUCTION MANUAL
Model No. :
112424
Power Up
After power up, All LED segments are on for a few seconds. And then icon RCC is flashing at
0.5Hz as it starts trying to synchronies with the time signal for maximum 10 min. If the time
signal is strong, icon RCC will be off, else It keeps flashing once per 2 seconds. In this 10
minutes. If the synchronization is successful, it will update the HOUR:MIN and other settings
with icon RCC on and the next synchronization will be started at beginning of each hour without
any indication. If the synchronization is fail, the icon RCC will keep flashing once per second.
Key Description
[MODE]
[SET]
[SNOOZE]
1
To manually set the clock.
When hour and minutes is displayed, press and hold [SET] for 2 seconds, it enter the
clock setting mode. You can using
digits is flashing. And then press [SET] to adjust the Month, date, weekday, second, hour
and finally the minute in order.
(Note that the Offset value will only be effective for the next synchronization. It has no
effect on the manually set hour.)
2
To set the alarm time and weekend
First Press [MODE] to enter Alarm 1 mode while alarm time is display, then press and
hold [SET] for 2 seconds the alarm hour will start flashing. Using
Press [SET] again to set the alarm minute, and then [set] again to set the weekend
Press once will display the Alarm 1 time, Press again to Alarm 2 time and
press again to Time mode. Sequence:
CLOCK TIME ALARM 1 ALARM 2
Press and Hold it for 2 seconds it will change to setting mode
which allow user set the current time/month/date/weekday/second
Hour/minute with key
It display the day of week
It display the second which is counting.
It display the Month and date.
Leaving it along for 5 seconds, it return to Hour and Minute Mode
CLOCK TIME
or
.
or
to adjust first the Offset while the offset
or
for adjusting.
Publicité
