Liberty Pumps PROVORE 380 Serie Manuel D'installation page 7

®
QuickTree settings for wide angle float ProVore
Float positions 1, 2, 3 and 4
are identified by a "flat"
stamped into the stainless
steel rod. 1 is highest, 4 is
lowest.
When servicing the QuickTree
tighten the screw with a Philips screw driver being sure to not overtighten. Flats have been stamped on the rod to designate float
positioning, and the screw should be tightened onto the flat. The tether length is the amount of cord between the clamp and float.
Control and alarm floats have different tether
lengths. See above chart for proper tether length
and correct rod position.
®
, place the switch cord into the trough or channel then slip the stainless steel rod through the clamp and
©Copyright 2015 Liberty Pumps Inc. All rights reserved
®
systems:
ROD
POSITION Alarm Float Control Float
1
2
3
4
TETHER LENGTH
(SWITCH TO CLAMP)
P380 & P680
3.5"
3.0"
7