ALPATEC RSB 2005 Mode D'emploi page 7

Notice RSB 2005 18/01/07 20:51 Page 7
THERMOST A T SETTING
THERMOST A T SETTING
Set the thermostat maximum. The lighting indicator comes on. When the room is at the required temperature,
carefully turn the thermostat anticlockwise until the fan goes off. The appliance will now switch on and off to
keep the room at the right temperature.
W ALL INST ALLA TION
W ALL INST ALLA TION
- Fix the wall support with the screws.
- Clip the lower hook of the wall support on the bottom of appliance. And clip the upper hook of the wall
support in the carrying handle of appliance.
- Install the appliance according to the referenced distances (as show on figure A).
50 cm
30 cm 30 cm
20 cm
Note : The appliance shall not be installed higher than 1,8m.
To remove the appliance, maintain a solid grip on the unit and push down upon the lower tongue of the wall
bracket.
SAFETY CUT -OFF WHEN OVERHEA TING
SAFETY CUT -OFF WHEN OVERHEA TING
This appliance is equipped of an automatic cut-off device in case of overheating. This device allows to stop
the appliance when the heat inside the appliance's body becomes too high.
This cut-off stops the heating element.
If the appliances stops, ensure you that the opening does not be obstructed.
CLEANING
CLEANING
Before cleaning, ensure that the appliance is switched off and unplugged.
Clean the outside with a dry cloth.
From time to time, clean the inside with a vacuum cleaner on a low setting.
After each season's use, we suggest that the appliance be cleaned with a cloth.
7