Publicité
Les langues disponibles
Les langues disponibles
ENG
1.
Set the main guiderail against the wall at the desired position and mark the drill points. Do this for both rails
and make sure they are parrallel and on the same height.
2.
If neccesary for safe installation to the extend of the prescribed windclass, add more fixing points to the
rails (2 diameters) and wall. The upper mounting point needs to be more than 30mm from the top of the
rail. As the case slides inside the rail with its mounting points.
3.
Mounting points need to be set in stone and not in the cement inbethween when mounted on a wall.
4.
In the case a cable or manual operating rod extends out of the back of the casing. Measure its position
and mark this position on the wall.
5.
Drill the mounting points in the wall.
6.
Mount the rails on the wall with appropriate fixing methods for the building situation and the forces appli-
cable to the required windclass.
7.
Check if the rails are mounted parallel and on the same height.
8.
Mount the casing on top of the rails.
9.
Unwind the fabric to the end of the rail.
10. Shove the ziprails with the funnel on the casing side on the fabric zipper.
11. Mount the clamp rail on the mainrail, this with the ziprail within. Make sure the foam springs are well settled
in place.
12. Attach the electrical wiring according to the motor manual.
13. Testrun the motor and if neccesary set the upper & lower stop position, see motor or remote manual.
Ø5
18.6
Ø10
34
1.8. Controle haaksheid / Controle le rectangle / Check squareness
1.9. Afregelen motor / Reglage fin course du moteur / Adjustment endstroke of the motor
NL
• Zie bijgeleverde handleiding van de motor en/of afstandbediening.
FR
• Voir manuel du moteur et/ou commande à distance livré.
ENG
• As specified in the motor or remote manual incuded in the package.
Winsol | Zonwering
Solfix 90RE - 110AR/RE - 150AR | Montage
18.6
34
Solfix 48x34
B1
B2
Rev. 8 maart 2018
Ø5
Ø10
34
34
D1=D2
B1=B2
2018
Solfix 73x34
Pag. 6/6
Publicité
