Ordering Replacement Parts; Technical Data - Einhell Royal AST 20 Mode D'emploi

Anleitung AST 20_SPK1 21.09.2006
GB
5. Operation
Important: Make sure that the hose is under
pressure only during use. Turn off the water supply
after use and empty the hose before winding it up.
Pull out the hose to the desired length.
Important: To prevent damage, pull on the hose
or the stopper and not on the spray nozzle.
There are 4 audible clicks each time the hose
reel turns one full rotation. The hose reel locks at
these clicks and is not drawn in automatically.
Check if the spray nozzle is closed and then
open the water supply.
The hose is now ready for use and you can start
with your work. Infinite adjustment of the water
jet from no water to fine spray to strong jet is
possible by turning the front part of the spray
nozzle.
When you are finished with your work, close the
spray nozzle first and then the water supply.
Before you wind up the hose, open the spray
nozzle again to release the remaining water
pressure and take the strain off the hose.
To wind up the hose, pull it out slightly and it will
wind itself back onto the reel automatically.
Important: Do not let go of the hose while it is
being wound up. This could damage the hose
and reel.

6. Technical data:

Length of connecting hose:
Length of pull-out hose:
Maximum operating pressure:
Hose diameter:
Weight:
6
12:53 Uhr Seite 6

7. Ordering replacement parts

Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
2.0 m
20.0 m
6 bar
1/2 inch
8,5 kg