Dimension Sketch Installation And Start-Up; Positioning; Electrical Connection - Crem Pulse Manuel D'instructions

DIMENSION SKETCH
INSTALLATION AND START-UP

Positioning

L
The minimum dimensions for the place of the machine must be 230 mm wide x 270 mm depth x 600 mm high.
Position the machine on a flat and stable surface, away from water and sources of heat.
It should be located in a dry environment, since excessive humidity will affect the machine negatively.
Do not cover the machine with plastic film or cloths.
At the first use, insert the hopper, fix the screw on the side and then turn on the machine.
WARNING!
Do not turn on the machine without the hopper.

Electrical connection

H
Only connect the machine to a grounded power supply.
Check the correct voltage and frequency on the technical data plate.
WARNING!
If the power cord is damage, it must be replaced by the manufacturer or by a
technical personnel in order to prevent any risk.
L
221 mm
MIN. 10 cm
Note:
i
Make sure that air is able to circulate behind
the machine (minimum 10 cm).
H Z
554 mm 264 mm
9