Publicité
Les langues disponibles
Les langues disponibles
Paper Jams and Motor Overloads
Your shredder is equipped with an automatic motor-overload
protection circuit which shuts off power to the shredder during
any of the following abnormal situations:
• Operating the shredder at maximum capacity continuously
for more than 2 minutes.
• Exceeding the shredding capacity.
• Leaving the shredder on when there is a paper jam.
Fixing a minor paper jam
1. After the motor stops, slide the switch to rev and pull the
remaining sheets of paper out of the feed opening.
2. Remove any un-shredded paper from the top and clear any
excess paper shreds from the feed opening. You are now
ready to resume normal shredding.
Fixing a major paper jam
1. Unplug the power cord from the wall outlet and wait at least 40
minutes for the thermal-overload protection to reset.
2. Slide the switch to the O position, then plug the power cord
into the wall outlet.
3. If paper was left inside the feed opening prior to the overload,
slide the switch to rev and pull the remaining sheets of paper
9
Publicité
