Bort TaloStabil Plus Sport Manuel D'utilisation page 11

5
Guide the Stabilo strap on the outer side of the ankle joint forwards diagonally
over the metatarsal downwards to the outer side of the foot.
6
In the next step, guide the strap through underneath the sole of the foot to the
inner side of the foot.
7
Then, draw the Stabilo strap upwards from the inside diagonally over the
metatarsal to the outer side of the ankle joint again. Raise the inner edge of
the foot slightly here.
8
Finally, fasten it onto the inner side from behind.
Tip: The tighter you tense the Stabilo strap, the greater the stabilising effect is.
Close the Velcro fasteners in order to avoid early wear to the Velcro surface.
Attention: Avoid damages to the knitted fabric with the Velcro fastening.
Removal
To remove the support, please grasp the lower edge and pull it down over the foot.
Tip: Close the Velcro fasteners in order to avoid early wear to the Velcro surface.
Material composition
Polyamide/COOLMAX
The sewn in textile label provides the precise material composition.
Cleaning information
Delicate wash 30 °C
Do not iron
Do not use fabric conditioner. Stretch back into shape and dry in the fresh air.
Close the Velcro fastenings to avoid damage to other laundry items.
(PA), polyamide (PA), elastane/LYCRA
®
Do not bleach
Do not clean chemically
(EL), silicone (SI).
®
Do not dry in a tumble dryer
EN
11