Fitting Instructions - Bort TaloStabil Plus Sport Manuel D'utilisation

EN
– do not wear it on open wounds
– do not use in case of intolerance of one of the materials used
– no re-use – this medical aid is intended for treating one patient
– whilst wearing the support, please neither use any creams nor ointments on or
around it as they can destroy the material.
– In order to avoid damages to the knitted support fabric, only attach the Stabilo
strap after successfully determining the size and trial fitting. Goods damaged by
the Velcro fastening cannot be returned.

Fitting instructions

Grasp the upper edge of the support and pull it over the foot until the tops of the
ankles are in the rounded pad recesses.
For stabilisation in case of inward rotation of the foot, that is to say raised
outer edge of the foot (viewed from the rear, the strap points outwards):
1
Guide the Stabilo strap on the outer side of the ankle joint forwards diagonally
over the metatarsal downwards to the inner side of the foot.
2
In the next step, guide the strap through underneath the sole of the foot to the
outer side of the foot.
3
Then, draw the Stabilo strap upwards from the outer side diagonally over the
metatarsal to the inner side of the ankle joint again. Raise the outer edge of
the foot slightly here.
4
Finally, fasten it onto the outer side from behind.
For stabilisation in case of outward rotation of the foot, that is to say raised
inner edge of the foot (viewed from the rear, the strap points inwards):
10