ero electronic MKS Manuel De Service page 108

DEFAULT CONFIGURATION PARAMETERS DEFAULT CONFIGURATION PARAMETERS DEFAULT CONFIGURATION PARAMETERS DEFAULT CONFIGURATION PARAMETERS DEFAULT CONFIGURATION PARAMETERS
The configuration parameters can be loaded with
predetermined default values. These data are the typical
values loaded in the instrument prior to shipment from
factory. To load the default values proceed as follows:
a ) The instrument must be in modify configuration mode.
b) By and pushbuttons select the "dF.Cn" parameter.
c ) Press pushbutton to select between table 1
(european) or table 2 (american) default set of
parameters; press FUNC pushbutton the display will
show:
This means that the loading procedure has been initiated.
After about 3 seconds the loading procedure is ended and the
instrument reverts to display the "dF.Cn" parameter.
d) To return to normal display mode, reach the "End"
parameter and select the "yES" indication,
e ) press the FUNC key
PARAMETER PARAMETER PARAMETER PARAMETER PARAMETER TABLE 1 TABLE 1 TABLE 1 TABLE 1 TABLE 1 TABLE 2 TABLE 2 TABLE 2 TABLE 2 TABLE 2
SEr 1 ErO ERO
SEr 2 1 1
SEr 3 19200 19200
SEr 4 7E 7E
P1 ----. ----. 5 23
P2
P3 0 0
P4 1200 2190
P5 SñOL SñOL
P6 Fb Fb
P7 nonE nonE
P8 H.A. H.A.
P9 nonE nonE
P10 H.A. H.A.
P11 nonE nonE
P12 H.A. H.A.
XKSserA-B0.PMD 2
P13 SPEC OPrt
P14 750 1380
P15 850 1560
P16 0.1(%) 0.1(%)
P17 0 0
P18 0 0
P24 nonE nonE
P25 AIr AIr
P26 rEv rEv
P27 OFF OFF
P28 rEv rEv
P29 OFF OFF
P30 OFF OFF
P31 0 0
P32 On On
P33 2 2
P34 30.0(%) 30.0(%)
P35 1.0(%) 1.0(%)
P36 00.20(m.s) 00.20(m.s)
P37 OFF OFF
P38 On On
P39 3 3
P40 bUñP bUñP
P41 0 0
P42 0 0
P43 nO.FL nO.FL
P44 Pid Pid
P45 0 0
P46 10(s.) 30(s.)
P47 0 0
P48 Fn.SP Fn.SP
P49 10 10
P50 0 0
P51 diS diS
P52 50 50
P53 10.00(m.s) 10.00(m.s)
P54 10 10
P55 0 0
Appendix A.2
12/09/2005, 10.49