Mounting Bracket - V-QUIPMENT Light Série Instructions D'installation

4

Mounting bracket

• Install the mounting bracket; use fasteners as indicated.
5 Steering cable and spent tube
• Route the steering cable through the boat from helm position to
outboard motor.
The spent tube (1) protects the inner cable
against the surrounding equipment and visa
versa.
• The protective hose (2), for transport purposes
only, can now be removed and discarded.
6 Entering cable
• Feed the inner cable through the helm unit while turning the
steering wheel to pull cable end to inside the rotary assembly.
• Check steering direction, making sure that when wheel is
turned to the right, the boat will turn to the right.
• Install spent tube cable cover by slipping it over the cable end.
• Use fasteners as indicated to secure the cable jacket and the spent
tube.
7 Helm unit
• Place the helm through the centre hole. There are multiple holes
for mounting the helm. Which ones you use will depend on your
particular installation location and cable routing.
• Use fasteners as indicated.
Light Series Cable Steering
7/16" 2.6 - 3.8 Nm (1.9 - 2.8 ft.lbf )
1/4-28 UNF x 1 3/8"
7/16" (1.9 - 2.8 ft.lbf )
2.6 - 3.8 Nm
1/4-28 UNF
7/16" 5.1 - 7.6 Nm (3.8 - 5.6 ft.lbf )
ENGLISH
1/4-28 UNF x 1 3/8"
1
2
7
VQ12060_A